How to Make a Miter Sled (Old Version)

May 27, 2014


Note: This is the older version of my miter sled video. Since then, I have created a new video on how to make a  miter sled that is higher quality.

This week I bought a brand new table saw and wanted to do a project that showcased it. For this project I used 3/4″ particle board and a scrap piece of 2×4. The first thing I did was made runners for the table saw tracks. I then attached those to the particle board with glue and wood screws. I then cut the board in half and added each 2×4 piece on a 45 degree angle. I glued and screwed those down into place and ran the sled halfway through my table saw. Now this miter saw sled is ready to be used!


You can email directly at


Visit the About Page to see Frequently Asked Questions

Contact Me

Filling out the form is the fastest way to get in touch with me

2 + 11 =